The installation shall be tested and approved by a registered installer and shall be issued with a certificate of compliance that it has been tested and complies with this part of the measure
Applied by Zimbabwe on the entire world and the entire world for 6807: Articles of asphalt or of similar material (for example, petroleum bitumen or coal tar pitch).
Applied by Zimbabwe on the entire world for 4407: Wood sawn or chipped lengthwise, sliced or peeled, whether or not planed, sanded or end-jointed, of a thickness exceeding 6 mm.
A: Protection of human life and health and E: Protection of the environment
Description of the measure
In the case of proof-graded 50 mm x 76 mm timber, test each piece in the sample in accordance with appendix C of ZWS 257.1. In the case of other mechanically stress-graded timber test each piece in the sample in accordance with ZWS 218 and verify that the lot has been correctly stress-graded./
Reference of the measure
Article 5.2, p. 10
Measure also domestic
Yes
Products affected by the measure.
Code
Product
Partial coverage
Partial coverage indication
Date in
Date out
4407
Wood sawn or chipped lengthwise, sliced or peeled, whether or not planed, sanded or end-jointed, of a thickness exceeding 6 mm.
Applied by Zimbabwe on the entire world for 3915.30: Of polymers of vinyl chloride, 3917.2: Tubes, pipes and hoses, rigid :, 3917.3: Other tubes, pipes and hoses : and 3917.40.00: Fittings
A: Protection of human life and health and E: Protection of the environment
Description of the measure
Test specimens from a pipe or fitting in the sample, cut a test piece of area approximatey 100 mm x 40 mm place it between the two plates and place the assembly and allow it to cool for 120 +- 5min
A: Protection of human life and health and E: Protection of the environment
Description of the measure
The tensile, bend, electrical resistivity and hydrogen embrittlement tests described in Appendix E to H shall be carried out on test pieces prepared from the samples selected.
Reference of the measure
Article 10, p. 13
Measure also domestic
Yes
Products affected by the measure.
Code
Product
Partial coverage
Partial coverage indication
Date in
Date out
7019
Glass fibres (including glass wool) and articles thereof (for example, yarn, woven fabrics).
A: Protection of human life and health and E: Protection of the environment
Description of the measure
The pan to be tested shall be placed on a firm, flat, horizontal surface with its outlet discharging freely into the air above a drainage channel or other device to carry away discharge. The shall be no obstruction within a distance of 150 mm of the pan outlet measured in the direction of the axis of the outlet
A: Protection of human life and health and E: Protection of the environment
Description of the measure
Additional tests require that is leak pressure, insulation resistance, earthing and high voltage tests inclusive shall be applied to all normal production bottle coolers
Applied by Zimbabwe on the entire world for 3923: Articles for the conveyance or packing of goods, of plastics; stoppers, lids, caps and other closures, of plastics.
The purpose of compulsory specification is to assist the implementation of the Plastic Packaging and Plastic Bottles Regulations in order to protect the environment
Coded list of objectives
E: Protection of the environment
Description of the measure
Test methods
3(a) Measure the thickness of the plastic film using the method described in SAZ-ISO4893, and check the results for compliance;
(b) Type of ink (nitrocellulose spot test) If Type A Ink is claimed, the claimant shall not exhibit any change of colour, the general principle is that a solution of diphenylamine in concentrated sulfuric acid is used to indicate the presence of nitrocellulose, the re-agent causes an almost instantaneous formation of a dark blue colour on contact with nitrocellulose.
CAUTION:
The substances used for this test are extremely dangerous. Gloves and safety glasses should be used throughout the preparation and use of this solution.
(i). Preparation of test solution.
A. Carefully mix together the following ingredients in a conical flask whilst cooling the flask under running water-
(1) 0.5g diphenylamine (C12 H11 N);
(2) 10,0 g water; and
(3) 30,0 g concentrated sulphuric acid (98%)
CAUTION:
Add the acid slowly to the water.
B. carefully add a further 60,0g of concentrated sulphuric acid, and mix gently.
C. transfer the contents of the flash to a dark glass bottle, and label and date the bottle,
NOTE:
The solution should have a shelf life of approximately one month. The solution will initially be a yellow/ orange colour, and it should be discarded and prepared afresh if it sows any signs of discolouration (which would probably indicate a reaction with light, oxidation or contamination).
(ii) Procedure
A. Place one drop of the test solution on a sample of the dried ink to be tested.
B. Check after thirty seconds for any colour change,
If the colour changes to the dark blue, it indicates the presence of nitrocellulose.”
Reference of the measure
SCHEDULE (Section 2 and 3)
Measure also domestic
Yes
Products affected by the measure.
Code
Product
Partial coverage
Partial coverage indication
Date in
Date out
3923
Articles for the conveyance or packing of goods, of plastics; stoppers, lids, caps and other closures, of plastics.
No
Description
Packaging that is made from thermo-plastic materials and covers plastic, and carrier packaging both domestically produced and imported for use within Zimbabwe
A: Protection of human life and health and E: Protection of the environment
Description of the measure
Use any suitable method to measure the dimension shown in Figure 1 and 4 to 30 (Inclusive) of the pipes or fittings taken in accordance with 5.1 for compliance with the relevant requirements
Applied by Zimbabwe on the entire world for 3920: Other plates, sheets, film, foil and strip, of plastics, non-cellular and not reinforced, laminated, supported or similarly combined with other materials. and 4010: Conveyor or transmission belts or belting, of vulcanised rubber.
A: Protection of human life and health and E: Protection of the environment
Description of the measure
The number of samples to be tested for compliance with the requirements of this standard shall be in accordance with table 3 Each sample shall be the full belt width and not less than 600 mm long
Reference of the measure
Article 15, p. 8
Measure also domestic
Yes
Products affected by the measure.
Code
Product
Partial coverage
Partial coverage indication
Date in
Date out
3920
Other plates, sheets, film, foil and strip, of plastics, non-cellular and not reinforced, laminated, supported or similarly combined with other materials.
Yes
plastics flat transmission beltingof textile construction for general use
4010
Conveyor or transmission belts or belting, of vulcanised rubber.
Yes
Rubber, balata or plastics flat transmission belting of textile construction for general use
Description
Rubber, balata or plastics flat transmission belting of textile construction for general use
A: Protection of human life and health and E: Protection of the environment
Description of the measure
Ring bend test The design of the assembly that applies the force shall be such that the knife edge makes contact over the full width of the ring, and the line of action of the applied force lies along a diameter of the central plane of the ring.
Applied by Zimbabwe on the entire world for 4404: Hoopwood; split poles; piles, pickets and stakes of wood, pointed but not sawn lengthwise; wooden sticks, roughly trimmed but not turned, bent or otherwise worked, suitable for the manufacture of walking sticks, umbrellas, tool handles or the like; chipwo and 4408: Sheets for veneering (including those obtained by slicing laminated wood), for plywood or for similar laminated wood and other wood, sawn lengthwise, sliced or peeled, whether or not planed, sanded, spliced or end-jointed, of a thickness not exceeding 6 m
A: Protection of human life and health and E: Protection of the environment
Description of the measure
Measurement of defects in the case of gum pockets, measure the length to the nearest 10 mm and measure the width (at widest point) and the depth to the nearest milimetre
Reference of the measure
Article 7.2, p.20
Measure also domestic
Yes
Products affected by the measure.
Code
Product
Partial coverage
Partial coverage indication
Date in
Date out
4404
Hoopwood; split poles; piles, pickets and stakes of wood, pointed but not sawn lengthwise; wooden sticks, roughly trimmed but not turned, bent or otherwise worked, suitable for the manufacture of walking sticks, umbrellas, tool handles or the like; chipwo
Yes
Hardwood poles, droppers, guardrail posts and spacer blocks
4408
Sheets for veneering (including those obtained by slicing laminated wood), for plywood or for similar laminated wood and other wood, sawn lengthwise, sliced or peeled, whether or not planed, sanded, spliced or end-jointed, of a thickness not exceeding 6 m
Yes
laths of hardwood
Description
Hardwood poles, droppers, laths, guardrail posts and spacer blocks
Applied by Zimbabwe on the entire world for 8544: Insulated (including enamelled or anodised) wire, cable (including coaxial cable) and other insulated electric conductors, whether or not fitted with connectors; optical fibre cables, made up of individually sheathed fibres, whether or not assembled with
All tests are to be carried out at ambient temperature and pressure, unless otherwise stated in the test method.
Reference of the measure
Article 6.2 p. 38-39
Measure also domestic
Yes
Products affected by the measure.
Code
Product
Partial coverage
Partial coverage indication
Date in
Date out
8544
Insulated (including enamelled or anodised) wire, cable (including coaxial cable) and other insulated electric conductors, whether or not fitted with connectors; optical fibre cables, made up of individually sheathed fibres, whether or not assembled with
A: Protection of human life and health and E: Protection of the environment
Description of the measure
The dynamic test shall be performed on two belt assemblies which have not previously been under load, except in the case of belt assemblies forming part of restraint system, where the dynamic test shall be performed on the restraint systems intended for one group of seats which have not previously been under loads.
Applied by Zimbabwe on the entire world for 3819.00.00: Hydraulic brake fluids and other prepared liquids for hydraulic transmission, not containing or containing less than 70% by weight of petroleum oils or oils obtained from bituminous minerals
A: Protection of human life and health, B: Protection of life and health of animals and E: Protection of the environment
Description of the measure
Determine the equilibrium reflux boiling point of a brake fluid by running duplicate samples according to the following procedure and averaging the results
Reference of the measure
Article 4, p.12-13
Measure also domestic
Yes
Products affected by the measure.
Code
Product
Partial coverage
Partial coverage indication
Date in
Date out
3819.00.00
Hydraulic brake fluids and other prepared liquids for hydraulic transmission, not containing or containing less than 70% by weight of petroleum oils or oils obtained from bituminous minerals
No
Description
Covers requirements for DOT 3 and DOT 4 fluids in hydraulic brake system of motor vehicles.
Applied by Zimbabwe on the entire world for 4009: Tubes, pipes and hoses, of vulcanised rubber other than hard rubber, with or without their fittings (for example, joints, elbows, flanges).
A: Protection of human life and health and E: Protection of the environment
Description of the measure
The plugs and socket-outlets and socket-outlet adaptors used for the tests shall be in clean, new condition at the commencement of the tests, and shall be in identical in all essential details with those to be used min service.
A: Protection of human life and health and E: Protection of the environment
Description of the measure
Take all linear measurements to the nearest 1 mm and measure each of the 12 units for compliance with dimensions and when applicable shell and web thickness